car diagnosis tool

How to Run a Auto on Chip Fat 1Remove water from the chip fat by heating it to 120 degrees Celsius working with a Bunsen burner car diagnosis tool. Cease heating after the mixture has stopped spitting and popping as this indicates there's no water left, based on the web site Make Biofuel. Permit to awesome.2Mix 250 ml of methanol and 4 g of sodium hydroxide in a separate beaker.

Ensure all the sodium hydroxide has dissolved then allow to awesome, says the Make Biofuel website.3Pour the sodium hydroxide and methanol mixture into a fresh beaker and add the boiled chip fat. The Make Biofuel website says this could only be carried out once the oil has cooled to less than 60 degrees Celsius. Leave the mixture to sit for two days to allow the biodiesel to separate from the glycerine also produced from the reaction.

Separate applying a beaker using a drain valve at the bottom.4Add an equal amount of water to the biodiesel to remove the excess glycerin not already filtered off. The Biodiesel Make website advises you to leave the water to settle in the beaker for about 12 hours ahead of draining. Repeat this 2-3 three occasions until the water draining off is clear.

Heat the biodiesel as much as about 130 degrees Celsius for 20 minutes to evaporate any residual water Auto diagnostics. Filter the biodiesel in a 5-10 micron filter.5Add some mineral diesel for the solution through cold weather running, in line with the Renewable Power UK internet site. This will stop issues with freezing and cold weather starts.