How you can Clear a Service Engine Code on a Chevy Auto code scanner
1Connect the scan tool to the DTC port below your dash. The port is rectangular-shaped using a plastic cap that slips off, revealing the pin ports the scan tool plugs into for information retrieval.
2Follow the directions within the scan tool's owner's manual to access and clear the code. After you have performed this procedure, the code are going to be cleared Obd2 scanner, and the light will shut off. In case you don't own a scan tool, continue to Step three.
3Disconnect the negative battery cable from the battery, leave it off for 1 hour then reconnect it. This can dump any temporary memory your Chevy's personal computer has stored. It is going to also generate a pass code which will clear itself immediately after driving the automobile for a handful of days. Most state emissions stations will fail you for those who have pass codes stored; so if you plan to have an emissions test performed just after clearing the codes this way, ensure you wait at the very least several days and drive the Chevy as substantially as you possibly can in that time span.
Related articles:
没有评论:
发表评论