How you can Transform a Dodge Fuel Pump Relieve the Fuel Method Pressure
1Locate the fuel pump relay. Depending in your particular automobile, this may be inside a energy distribution center inside the engine compartment or underneath the dashboard.
2Unplug the fuel pump relay.
3Start the engine and let it idle till it stalls. Turn the ignition switch "off."
4Re-install the fuel pump relay.Remove the Fuel Pump.
5Drain the fuel tank, if necessary Car Diagnostic Tools, into an authorized fuel container using a hand siphon pump.
6Disconnect the black, negative battery cable.
7Raise the rear of the vehicle using a floor jack and safely support it on two jack stands.
8Disconnect the vapor line from the Evaporative Emissions (EVAP) canister tube in case your certain Dodge model is equipped with one particular subsequent for the fuel tank.
9Remove the EVAP canister using a wrench or ratchet and socket, if necessary, to produce area to lower the fuel tank.
10Disconnect the fuel line from the pump assembly by depressing the quick-connect retainer tabs and pull the line connector from the fitting.
11Unplug the fuel pump electrical connector type the pump assembly.
12Disconnect the vent tube and any other line connected to the pump assembly.
13Support the fuel tank having a floor jack and take away the tank strap bolts using a ratchet Auto diagnostic tool, ratchet extension and socket.
14Lower the tank just adequate to obtain access for the fuel pump assembly.
15Remove the fuel pump assembly by disconnecting the module locknut making use of a spanner wrench or related tool.
16Lift the fuel pump assembly off the fuel tank and discard the O-ring seal.Install the Fuel Pump.
17Remove the old pump from the assembly and install the new a single.
18Install the fuel pump assembly on the tank along with a brand new O-ring seal. Ailing the tab on the underside in the fuel-pump module flange with all the notch on the fuel tank and tight the locknut.
19Lift the tank and set up the tank straps and mounting bolts.
20Connect the vent tube if equipped.
21Plug the fuel pump electrical connector towards the fuel pump assembly.
22Connect the fuel line to the fuel pump and any other lines you disconnected from the assembly in your distinct Dodge model.
23Install and connect the EVAP canister in the event you had to take away it.
24Lower the car.
25Connect the black, unfavorable battery cable.
Related articles:
没有评论:
发表评论